Floating Point Coprocessors :: essays research papers

Floating Point Coprocessors   Ã‚  Ã‚  Ã‚  Ã‚  The designer of any microprocessor would like to extend its instruction set almost infinitely but is limited by the quantity of silicon available (not to mention the problems of testability and complexity). Consequently, a real microprocessor represents a compromise between what is desirable and what is acceptable to the majority of the chip's users. For example, the 68020 microprocessor is not optimized for calculations that require a large volume of scientific (i.e. floating point) calculations. One method to significantly enhance the performance of such a microprocessor is to add a coprocessor. To increase the power of a microprocessor, it does not suffice to add a few more instructions to the instruction set, but it involves adding an auxiliary processor that works in parallel to the MPU (Micro Processing Unit). A system involving concurrently operating processors can be very complex, since there need to be dedicated communication paths between the processors, as well as software to divide the tasks among them. A practical multiprocessing system should be as simple as possible and require a minimum overhead in terms of both hardware and software. There are various techniques of arranging a coprocessor alongside a microprocessor. One technique is to provide the coprocessor with an instruction interpreter and program counter. Each instruction fetched from memory is examined by both the MPU and the coprocessor. If it is a MPU instruction, the MPU executes it; otherwise the coprocessor executes it. It can be seen that this solution is feasible, but by no means simple, as it would be difficult to keep the MPU and coprocessor in step. Another technique is to equip the microprocessor with a special bus to communicate with the external coprocessor. Whenever the microprocessor encounters an operation that requires the intervention of the coprocessor, the special bus provides a dedicated high- speed communication between the MPU and the coprocessor. Once again, this solution is not simple. There are more methods of connecting two (or more) concurrently operating processors, which will be covered in more detail during the specific discussions of the Intel and Motorola floating point coprocessors.   Ã‚  Ã‚  Ã‚  Ã‚  Motorola Floating Point Coprocessor (FPC) 68882   Ã‚  Ã‚  Ã‚  Ã‚  The designers of the 68000-family coprocessors decided to implement coprocessors that could work with existing and future generations of microprocessors with minimal hardware and software overhead. The actual approach taken by the Motorola engineers was to tightly couple the coprocessor to the host microprocessor and to treat the coprocessor as a memory-mapped peripheral lying inside the CPU address space. In effect, the MPU fetches instructions from memory, and, if an instruction is a coprocessor instruction, the MPU passes it